How to Connect a Macard WiFi Extender to Synology RT6600ax Router

Synology RT6600ax router is pretty solid but even the best routers are unable to cover every corner of your home or office. That is where your Macard WiFi extender comes in. The Macard WiFi extender setup can look difficult if you have not done it before especially with a router like the Synology RT6600ax.

In this blog we will see how to connect a Macard Extender to Synology RT6600ax Router in simple words without the need of tech guy.

Everything You Will Need

Before discussing the actual setup, make sure that you have all the essentials:

• Your Synology RT6600ax router is up and running.
• The Macard WiFi extender is plugged into a power source somewhere roughly halfway between your router and the WiFi dead zone.
• A smartphone or laptop to do the setup.

Make sure your router is having a stable WiFi signal. If your Synology router has multiple bands like the 2.4 GHz and 5 GHz then remember that the extender will usually select the 2.4 GHz band by default, but some of the models handle both.

Step 1: Connect to Your Macard Extender’s Network

Make sure to connect your device such as phone or laptop with the Macard extender’s network. . This is usually something like “Macard_Extender_XXXX”. You will find the exact name on a sticker on the device or in the manual.

• On your phone or laptop, look for the nearby WiFi networks.
• Make sure to connect to the Macard extender network. No password is required at this point or it might be “admin” or “12345678” — check the manual).
• If you are unable to find the network then reset the extender by pressing down the reset button for about 10 seconds till the time LED lights blink.

Step 2: Access the Macard Extender Admin Page

Once you are connected to the extender’s network, open a web browser and enter the IP address for the Macard WiFi extender setup page. Usually, this is something like:
192.168.10.1

If that does not work, check the label or manual again.

• You will get a login prompt.
• The username and password is usually “admin” for both or “admin” for “admin” and “password” for “password”. Make sure to check your specific extender manual.

If the login doesn’t work, go for another reset and try again.

Step 3: Run the Setup Wizard

Once you are inside the admin page, you will find a setup wizard. This is where you tell the Macard extender which router to repeat.

• You have to choose your Synology RT6600ax’s WiFi network from the list.
• Make sure to enter the correct password.
• Choose if you want the same name for extender wifi ad of router or want to change the network name.
• The extender will reboot. Wait for about a minute or two.

Step 4: Placement and Testing

Under this step the worth of setup is validated.

• Place the Macard WiFi extender in between of your router and the dead zone area. This should be close enough to catch a strong signal from the Synology RT6600ax.
• The extender’s LEDs should show a solid or blinking light which indicates that it is connected properly.
• Confirm to connect your device to the extended WiFi network.
• Run a speed test or just browse to see if your internet is actually better.

If it is still slow or drops out then shift the extender closer to your router and try again. Sometimes even a few feet can make a huge difference.

Pro Tips for Macard WiFi Extender Setup

1. Firmware updates matter: Look for any firmware updates through the admin page. Sometimes errors get fixed that helps to make your extender more stable.
2. Avoid interference: the extender is to be placed away from microwaves, cordless phones or thick walls.
3. Restart if stuck: If the extender looks stuck or not connecting properly then a simple reboot can solve the issue.
4. Use Ethernet if possible: Some Macard extenders support a wired connection to the router for faster and more reliable bridging.

FAQs